Brand: Olimex
Product Code: ARM-USB-OCD-H
Availability: Pre-Order
Price: £54.95
Ex Tax: £54.95
Qty:     - OR -   Add to Wish List
Add to Compare

This high-speed USB 2.0 JTAG dongle device can be used with all ARM devices for programming and debugging. It is a first on the market 3-in-one USB JTAG debugger that offers JTAG, RS232 and power supply in one compact product.


  • First on market three-in-one USB JTAG debugger - offers JTAG,  RS232 (full modem signals supported) port & power supply all in one compact device
  • High-speed USB 2.0 JTAG dongle interface, can be used with all ARM devices for programming and debugging.
  • Uses ARM's standard 2x10 pin JTAG connector
  • Supports ARM targets working in voltage range 1.65 – 5.0 V DC
  • Supports adaptive clocking RTCK
  • Software supported by OpenOCD (open source) debugger
  • Adds virtual RS232 port to your computer with all modem signals like: DTR, DSR, DCD, RTS, CTS, Rx, Tx
  • Can be used as power supply to your target board with 5V USB source current is limited with resettable fuse at 300mA, at the different output voltage the maximum current is different: 5V/200mA, note that this also depend on your USB host current capabilities, if other USB devices are attached to your computer or if the laptop is running on batteries these figures may be different and depend on your computer USB host.
  • Downloadable Windows installer for full featured and open source tools as alternative to the commercial ARM development packages: GCC C compiler, openOCD debugger and Eclipse IDE.
  • Works with IAR EW-ARM 5.50 or newer
  • Dimensions 50x40 mm (2x1.6") + 20 cm (8") JTAG cable + 30 cm (12") power supply cable







Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Secured by PayPal
LimeTrace Electronics © 2017